3)BGP Update Source Modification
Objective: Configure a BGP peering relationship between R1 and R3. R1 should peer with R3's Ethernet interface, while R3 should peer with R1's Serial interface. R1 should use the source address 31.0.0.1 when sending BGP packets to R3.
Ok, this I had already done in the above lab, one good point to note here is that the update-source command will still work if its present on just one router, I mean after all we only need one active tcp session between the two routers. So we are good here, in the lab though it would definitely be better to configure the update-source command on both R1 and R2!
prometheus SNMP lab1
6 years ago
No comments:
Post a Comment